Loosen Snare retaining screw, located through hole in upper housing, just enough to release the Snare.
Remove Snare mounting screw on lower housing.
Pull out Snare.
TO REMOVE POWER BAND
Loosen Snare retaining screw, located through hole in upper housing, just enough to release the Snare.
Push down on Trigger and pull out Push Rod assembly.
Remove Power Band from Rod assemble.
TO INSTALL SNARE
Reverse previous steps.
Place the Equalizer in a vertical position (Snare up), push Trigger in, allowing Push Rod to advance into upper housing until Snare retaining screw is accessible through hole. Push Snare into the closed position until retaining loop engages the Push Rod. Guide the retaining loop of the Snare into the slot of the Push Rod and clear of the retaining screw- tighten screw. Do Not Over Tighten!
TO INSTALL POWER BAND
Reverse previous steps. Guide Push Rod assemble through Trigger. To reattach Snare to Push Rod, place the unit in a vertical position (Snare up), push Trigger in, allowing Push Rod to advance into Upper Housing until Snare retaining screw is accessible through hole. Push Snare into the closed position until Retaining Loop engages the Push Rod. Guide the loop into the slot of the Push Rod and clear of the Retaining Screw- tighten screw. Do Not Over Tighten!
